Skip to content Menu

You are here:

ProSens - Continuous dust measurement

The ProSens was specially developed to carry out reliable dust measurement on clean sides after filters.

  • Dust measurement in any channel, including large diameter
  • Output of dust level as a trend or absolute value
  • ATEX-certified
  • Measurement of dust concentration at high temperatures


ProSens was specially developed to carry out reliable dust measurement on clean sides after filters.
The measuring device provides measurement values for dust concentration, either as a trend signal or as absolute values (after calibration) for emission measurement.

ProSens is used:

  • if the dust concentration is to be output as an absolute value in mg/m3.
  • for exact measurements even with large channel diameters.
  • for applications in explosion hazard zones
    (GasEx-Zone 1, DustEx-Zone 20)
  • for the measurement of dust concentration even at high temperatures.


Basic principle of the ProSens is the electrodynamic effect.
If the dust to be measured is constant, then the generated measuring signal is proportional to the dust concentration, even if there are dust deposits on the measuring probe. Experience shows that the measuring method provides very exact results with little required maintenance.

A complete measuring system consists of these components:

  • Standard 1” socket
  • ProSens sensor
  • MSE 300 evaluation unit

This unit can be supplied in a field housing with touch panel display or as a DIN rail version.
In case of a DIN rail version also a software for parameter setting will be supplied.

Mounting and Installation

The ProSens can be installed in metal channels and pipelines.
The installation should take place away from any curves and other inserts such as flaps and valves.
The distance between the sensor rod and inserts in the channel should be at least 3 times the channel diameter in every flow direction.
Non-metallic channels must be sheathed using a metal sleeve, a metal foil or a close-mesh metal grid over a length of at least 5 times the channel diameter.

After determining the installation location, a hole must be drilled in the channel wall to insert the welding casing flush. The casing is now welded into place vertically to the channel. The sensor rod is then inserted in this and fastened with a fixing screw. The length of the sensor rod should at least 1/3 and at most 2/3 of the channel diameter.
It can be shortened to the respective optimal length (up to 70 mm) without a problem.

Technical Data

Application examples

Detection of metal dust in a clear gas site after bag filter
read more
Quantity measurement of filter dust in clear gas pathes
read more
Lime detection
read more
Filter leakage detection in a hazardous area (Ex)
read more

More dust meters