LEAK LOCATE 320 - Filterbewaking voor schade en lekkages

U befindt zich hier:Startpagina · Producten · LEAK LOCATE 320 - Filterbewaking voor schade en lekkages

Filterbewaking op filterschade en filterlekkage in filtersystemen

Filterbewaking voor het bewaken van elektrodynamische filters in industriële meerkamer
filtersystemen op filterschade en filterlekkage

  • Proactieve filterbewaking van meervoudige filtersysteem
  • Detectie van het ontstaan van filterschade
  • Detectie van de desbetreffende filterkamer bij een gebroken filter
  • Bespaar op materiaalkosten, downtimekosten en onderhoudskosten
  • Rookgastemperatuur tot 150 °C (optioneel: tot 250 °C)
  • Voor droge toepassingen
  • Inclusief 4 sensoren
  • Uit te breiden tot 32 sensoren
  • Digitale inputs en outputs
  • Externe verbindingen: USB 2.0 (type A), ethernet (RJ45/100 Mb/s)




    LEAK LOCATE 320 serves primarily to detect filter damages or incoming filter breaks at an early stage.
    The key advantage of the LEAK LOCATE 320 system is the ability to locate the filter selection where the damage occurred.
    Further features with LEAK LOCATE 320:

    • advance warning at degradation of the filter
    • significant savings in time and costs of maintenance
    • to reduce probability of large emission incidents


    LEAK LOCATE 320 uses the electrodynamic measurement principle. If the dust to be measured is constant, then the generated measuring signal is proportional to the dust concentration, even if there are dust deposits on the measuring probe. Experience shows that the measuring method provides very exact results with little required maintenance.

    A complete measuring system consists of these components:

    • Welded casing to serve as a sensor receptacle
    • LEAK LOCATE 320-sensor



    Technical data

    Sensor Ambient Air Temperature -20 ... +50 °C
      Stack Gas Temperature 125 °C standard or 250° C option
      Stack Connection 1½ BSPT, ½ BSPP, NSPM, NPT
      Enclosure Rating IP 65
      Rod Length 100 mm to 1000 mm
      Air Purge Connection ½ inch BSPP
    ½ inch NPSM
    1½ inch BSPT or NPT
      Power Requirements 24 V DC (from PLUS-Controller)
      Sensor probe check Automatically (optional)
    PLUS Controller Data Number of sensors 4 up to 32 sensors
      Ambient Air Temperature -20 ... +45 °C
      Power Requirements 100 ... 240 V AC, 1 A
      Data-Logs Impulse (4 hours @ 1 s for 4 sensors)
      Ethernet ModBus TCP
      Outputs (standard) 1 x RS 485 (ModBus RTU)
    4 Relais (2 A @ 250 V, user configurable)

    In welke meettechniek bent u geïnteresseerd? (Quickfinder)