FlowJam Plus - Monitor voor materiaalstromen met verstoppingsdetector

U befindt zich hier:Startpagina · Producten

FlowJam Plus -
Monitor voor materiaalstromen
met verstoppingsdetector

De FlowJam Plus is de nieuwe ontwikkeling voor gevestigde FlowJam sensor die de toegevoegde waarde in duizenden applicaties heeft bewezen:

  • Snelle detectie van materiaalstroom (flow/no flow)
  • Aanvullende functie voor de detectie van verstoppingen of materiaalstroom onderbrekingen
  • Functioneert zonder direct contact middels het gebruik van microgolven
  • Zeer betrouwbare meting doordat microgolven door materiaalophopingen heen gaan
  • Metingen kunnen van buitenaf in alle niet-metalen tankwanden, behuizingen, slangen of leidingen worden gedaan
  • Kan gebruikt worden in moeilijke omstandigheden zoals bij hoge temperaturen en hoge druk tijdens bedrijf. Verder is er een versie beschikbaar voor ATEX zones (met behulp van een proces adapter).


The FlowJam Plus sends microwaves into the pipeline in which the material flows. This may be a freefall pipeline or a pneumatic transport system.
The microwave signals are reflected by the moving solid particles. A shift in the Doppler frequency between the emitted and received signals means that the material is moving, in other words "Flow". If this Doppler shift does not take place, there is no material movement and the sensor indicates "NoFlow".
If this state occurs, the FlowJam Plus can detect on the basis of clear characteristic values from the reflection signal whether a blockage has formed from below or the material supply has been interrupted from above. This switching condition is output by a second relay.

Application examples

•    Transfer point

Chips of wood are transported by two screw conveyors in a biomass plant.
At the transfer point between the screw conveyors, the FlowJam Plus monitors the flow of material.
In the case of a material flow interruption, it is now possible to detect quickly whether there is a problem because the lower screw no longer removes any material or the feed screw no longer supplies material.




•    Material infeed to a rotary feeder

In a lime plant, lime is conveyed into the inlet of a rotary feeder via a vertical downpipe.  At this point, it should be ensured that there is always a sufficient material flow. When the material column reaches the sensor position in the fall line, the FlowJam Plus signals exactly this state.  With this information, the material feed can be controlled better.

Mounting and Installation

The FlowJam Plus sensor is installed on the line
using a G 1½-inch threaded port.








SystemA complete measuring point consists of the following components:•     FlowJamPlus sensor•     DIN rail connector

Technical Data

Sensor Housing material Stainless steel 1.4571
  Protection type IP 65
  Process temperature - 20 ... + 80 °C
- 20 ... + 220 °C (with process adapter)
up to 1000 °C (with ceramic flange)
  Ambient temperature - 20 ... + 60 °C
  Operating pressure max. 1 bar / Max. 20 bar (with process adapter)
  Power supply 18 ... 24 V DC / AC
  Operating frequency 24.125 GHz; ± 100 MHz
  Transmission power max. 5 mW
  Weight 1,0 kg
  Dimensions Housing: Length 216 mm / Diameter 52 mm
Thread: Length 30 mm / Diameter G 1 ½"
Transmitter (DIN rail) Power supply 18 ... 24 V DC
  2 x relay output
- Voltage
- Current
- Consumption

Max. 250 V AC
Max. 1 A
Max. 60 W
  Communication USB
  Response Time 1 ... 15 s (infinitely variable)
  Weight Approx. 172 g

In welke meettechniek bent u geïnteresseerd? (Quickfinder)